Great Gear print!

Posted on July 20, 2011


Pretty excited about todays gear print.

I adjusted the Y axis because I noticed it was rubbing against a rod which is very close to the bottom of it. I basically inverted the rod clamps so it brought it higher which does reduce my clearance height, but thats OK since I can still print up to 100mm high (untested).

The gear is part of the Accessible Wades Extruder downloadable on Thingiverse: http://www.thingiverse.com/thing:6713

The updated version of the extruder is basically adding a hinge to the idler seen here: http://www.thingiverse.com/thing:8252
Here are some pics!

First few layers

Last layer

Temp=185C in repsnapper (thermistor not so sensitive I guess)

awesome 66.98 Diameter

Advertisements